Changes between Version 26 and Version 27 of cLTE/cHardware/cAirSynergy

Timestamp:

Apr 6, 2017, 7:18:14 PM (7 years ago)

Author:

jkol

Comment:

—

cLTE/cHardware/cAirSynergy

@@ -1 +1 @@
 === !AirSynergy 2000 ===
 [[TOC(cLTE*, depth=3)]]
+
+==== Hardware Installation ====
+
+  !AirSynergy Connections:
+
+  [[Image(Slide1.PNG, width=400px)]]
+
+  || 1. || Networking || Copper ethernet (1000BASE-T) ||
+  || 2. || Power || Connect power cable to -48 power supply with the provided cable||
+  || 3. || Serial Console (optional) || If needed for debugging ||
+
+[[br]]
+  Fully connected !AirSynergy without weatherproofing covers should look like this:
+
+  [[Image(as2000-populated.jpg, width=400px)]]
+
+[[br]]
+===== Power Supply =====
+
+  The !AirSynergy supports direct connection to a -48VDC nominal power source.
+  [[br]]Operating Voltage Range: -40.5 to 57 VDC
+
+  A power supply capable of 120W or greater is recommended (eg. Mean Well CLG-100-48).
+
+  [[Image(Slide2.PNG, width=600px)]]
+
+====== Power Supply !Connector/Cable ======
+
+  TODO
+
+[[br]]
+===== Network Connectivity =====
+
+  Network connectivity is done via copper gigabit ethernet (1000BASE-T).
+
+[[br]]
+===== Serial Debug =====
+
+  The base station has a 9 pin connector (hidden behind a black hex bolt next to the port marked "ETH") which allows access to the serial console. This is useful for recovery purposes when the base station does not respond via software, SSH, or web interfaces. See [wiki:cLTE/cHardware/cAirspanLTEBaseStationSerialConsole Airspan LTE Base Station Serial Console] for information on cable construction and serial port parameters.