= MiMAX Pro RG231 (Indoor Gateway) = [[TOC(Internal/*)]] Please make sure that you have the [attachment:MiMAX-Pro_AWB_RG231_81-1.0.3.2-5.2.7.3.zip latest firmware] installed before configuring the device; the firmware upgrade procedure is described in the [attachment:'MiMAX-Easy (RG231)_User_Guide.pdf' user guide]. By default, the device has fixed IP address of '''192.168.1.1'''; set your machine to any 192.168.1.X address and connect it to the gateway with the Ethernet cable. Management is mostly done over http at port 80 (but can be also performed over the [wiki:Internal/WimaxRG231#telnet telnet session]). == GENI Configuration == The device needs custom WiMAX configuration that is not described in the manual. In order to get to the set of pages for WiMAX configuration log in with ('''case is important'''): - username: Operator - password: oper1234 You should now get extended menu that includes '''WiMAX''' menu button once you switch to '''Advanced Settings''' mode as shown in Figure 1. [[Image(menu.jpg, width=500)]] A. Select '''WiMAX''' and go to the "Profile Settings" on the sub-menu (should be the default page once you select WiMAX) and set it to match your configuration. For most sites it should looks something like this: 1. Home Operator ID: '''44:51:db''' 1. Operator Name: '''GENI''' 1. Operator Restrictions: '''none''' 1. Add the [wiki:WiMAX/00/01#a1.3.5GENIWiMAXSitesandContacts list of frequencies and bandwidths for your site] 1. Enable Authentication: unchecked The filled-in page should look like the one shown in Figure 2 and 3. [[Image(Profile1.jpg, width=600)]] [[Image(Profile2.jpg, width=600)]] Select '''Apply''' button in the upper right corner. B. ('''optional but recommended''') Select the '''Operator List''' on the sub-menu and add newly created operator (for the operator from the example above it would be: 1. Operator ID: '''44:51:db''' 1. Operator Name: '''GENI''' 1. Enable: checked and hit '''Add''' button (Figure 4). [[Image(Operator.jpg, width=600)]] C. Chose the type of the basestation you are connecting to by selecting '''Advanced Config''' on the sub-menu and then choosing the BS type from the pull-down meny. Default settings shouls work for both NEC and Airspan BSs. The browser snapshots for both BS types are shown in the table below. ||= NEC =||= Airspan =|| || [[Image(Nec.jpg, width=300)]] || [[Image(Airspan.jpg, width=300)]] || D. Reboot the gateway (the '''Reboot''' button should have appeared above the menu once you applied "Profile Settings"; otherwise go to '''System''' and select '''Restart''' ). == Telnet Management == #telnet The device is actually an [https://openwrt.org/ OpenWRT based gateway]; you can telnet into it with: - username: root - password: wimax-iad