wiki:Old/WiMAX/04/01
close Warning: Can't synchronize with repository "(default)" (/common/SVN/wimax does not appear to be a Subversion repository.). Look in the Trac log for more information.

Version 1 (modified by seskar, 11 years ago) ( diff )

Steps for setting up the WiMAX BTS on ORBIT

Please note: Do not restart BTS until all changes are complete. If you do happen to restart, you will have to use the serial interface to connect to the BTS.

  • Change the IP address and correct configuration on the RF card.
    • Login to the BTS as root on 192.168.1.10/24
    • Copy the attached networkenv.orbit file to /flash/networkenv
    • Use wiset commands below to correct configuration on the BTS:
      wiset authgw_id 0x41534E47
      wiset authgw_port 0x08B7
      wiset asngw_id 0x41534E4757303030
      wiset asngw_dp_port  0x08B7
      wiset asngw_ep_port 0x08B7
      wiset bs_rx_port 0x08B7
      wiset bsid 0x303030303030
      wiset frequency  2551500
      wiset bs_tx_power 40
      wiset bw_mode 0
      wiset dlul_ratio 2
      wiset ttg 296
      wiset rtg 168
      wiset framesync_mode 2
      wiset antenna_gain 0
      
      # Other wiset commands changed to appropriately reflect new IP settings.
      wiset authgw_ip 0x0A030047
      wiset asngw_dp_ip 0x0A030047
      wiset asngw_ep_ip 0x0A030047
      
      
  • Change settings on the N/W card.
    • Login to the N/W card at 192.168.1.42/24 again as root, and change the IP configuration for eth1 in the /etc/network/interfaces file as :
      auto eth1
       iface eth1 inet static
           address 10.3.0.51
           network 10.3.0.0
           netmask 255.255.0.0
           broadcast 10.3.255.255
           gateway 10.3.0.1       
      

Attachments (3)

Note: See TracWiki for help on using the wiki.