wiki:Old/WiMAX/04/01
close Warning: Can't synchronize with repository "(default)" (/common/SVN/wimax does not appear to be a Subversion repository.). Look in the Trac log for more information.

Version 2 (modified by seskar, 14 years ago) ( diff )

Name changed from Configuration/BS to WiMAX/Configuration/BS

Steps for setting up the WiMAX BTS on ORBIT

Please note: Do not restart BTS until all changes are complete. If you do happen to restart, you will have to use the serial interface to connect to the BTS.

  • Change the IP address and correct configuration on the RF card.
    • Login to the BTS as root on 192.168.1.10/24
    • Copy the attached networkenv.orbit​ file to /flash/networkenv
    • Use wiset commands below to correct configuration on the BTS: 
      wiset authgw_id 0x41534E47
wiset authgw_port 0x08B7
wiset asngw_id 0x41534E4757303030
wiset asngw_dp_port  0x08B7
wiset asngw_ep_port 0x08B7
wiset bs_rx_port 0x08B7
wiset bsid 0x303030303030
wiset frequency  2551500
wiset bs_tx_power 40
wiset bw_mode 0
wiset dlul_ratio 2
wiset ttg 296
wiset rtg 168
wiset framesync_mode 2
wiset antenna_gain 0

# Other wiset commands changed to appropriately reflect new IP settings.
wiset authgw_ip 0x0A030047
wiset asngw_dp_ip 0x0A030047
wiset asngw_ep_ip 0x0A030047
  • Change settings on the N/W card.
    • Login to the N/W card at 192.168.1.42/24 again as root, and change the IP configuration for eth1 in the /etc/network/interfaces file as : 
      auto eth1
 iface eth1 inet static
     address 10.3.0.51
     network 10.3.0.0
     netmask 255.255.0.0
     broadcast 10.3.255.255
     gateway 10.3.0.1

Attachments (3)

Note: See TracWiki for help on using the wiki.