= Wireless = {{{ Set WIRELESS parameters (0) @@@Text for initrang_st_subchannel@@@ (0) Initial backoff window size for handoff. (3) @@@Text for framesync_mode@@@ (2) Support permutation mode. (0) @@@Text for dlulration@@@ (0x00) @@@Text for bwreq_st_symbol@@@ (2) @@@Text for min_phy_rate_be@@@ (QPSK 1/2 (0)) @@@Text for pwr_adjust_threshold@@@ (12) Maximum rx power (-45) Number of handover ranging codes. [0..255] (64) @@@Text for bcp_ie_transmit_count@@@ (117) @@@Text for admission_threshold@@@ (0) Default RSSI averaging parameter on DCD messages. (0x00) Contention-based reservation timeout [0..255] (8) @@@Text for odu_alm_control@@@ (0x10000000) Compressed map on/off (0) @@@Text for harqack_st_subchannel@@@ (33) @@@Text for frame_adjust_threshold@@@ (500000) Segment on/off (0) @@@Text for initrang_st_symbol@@@ (0) Final backoff window size for contention bandwidth requests, expressed as a power of 2. This is encoded in the UCD message in the MAC layer. [0..15] (15) Bandwidth mode [0 = 10MHz, 1=7MHz, 2=5MHz] (0) @@@Text for feedback_no_subchannel@@@ (29) Minimum PHY rate for Non-Real-Time Polling Service. (QPSK 1/2 (0)) @@@Text for odu_noise_floor@@@ (40) BS transmit power offset (0) Number of bandwidth request codes available. [0..255] (64) @@@Text for mac_version@@@ (6) @@@Text for multicast_repetition_cnt@@@ (6) Default CINR averaging parameter on DCD messages. (0x03) @@@Text for periodic_backoff_end@@@ (15) @@@Text for rf_cable_len@@@ (0) Number of segments (0) @@@Text for harqack_st_symbol@@@ (0) Initial backoff window size for contention bandwidth requests, expressed as a power of 2. This is encoded in the UCD message in the MAC layer. [0..15] (3) @@@Text for sdu_max_delay@@@ (5000) Preamble number. Set different nunber for each BS and Segment from each other. The cell ID / segment # is derived from this parameter.[0..113] (0) @@@Text for bwreq_no_subchannel@@@ (6) Minimum PHY rate for Real-Time Polling Service (QPSK 1/2 (0)) @@@Text for aging_timeout@@@ (30) Permutation base (0x00) @@@Text for feedback_no_symbol@@@ (3) @@@Text for fairness_count_reset@@@ (2) @@@Text for initrang_interval@@@ (1) BS transmit power (40) Number of periodic ranging CDMA codes available [0..255] (64) @@@Text for gms_enable@@@ (0x06) @@@Text for dcducd_repetition_cnt@@@ (6) @@@Text for periodic_backoff_start@@@ (3) @@@Text for rx_ho_ranging_max@@@ (0) Used UL subchannel group. (0x0000000007FFFFFFFF) @@@Text for initrang_no_subchannel@@@ (6) Final backoff window size for initial ranging contention, expressed as a power of 2. This is encoded in the UCD message in the MAC layer. [0..15] (15) @@@Text for fn_randseed@@@ (0) PRBS_ID for 2nd zone [0..2] (0) @@@Text for bwreq_no_symbol@@@ (1) Minimum PHY rate for Extended Real-Time Polling Service (QPSK 1/2 (0)) Receive transmit transition gap (units: PS) (168) Antenna gain of BS (units: DBi) [0..255] (0) @@@Text for feedback_st_subchannel@@@ (6) @@@Text for fairness_mode@@@ (1) Number of initial CDMA ranging codes [0..255] (64) @@@Text for dlmap_repetition_cnt@@@ (6) @@@Text for harqack_no_subchannel@@@ (2) Center frequency (2590000) @@@Text for siiadv_interval@@@ (10) Final bakoff window size for handoff. (15) @@@Text for initrang_no_symbol@@@ (2) Used DL subchannel group. (0x3F) @@@Text for rx_initial_ranging_max@@@ (4) DL permutation base for 2nd zone. [0..31] (0) Initial backoff window size for initial ranging contention, expressed as a power of 2. This is encoded in the UCD message in the MAC layer. [0..15] (3) @@@Text for bwreq_st_subchannel@@@ (0) @@@Text for ul_pusc_rotation@@@ (0) @@@Text for feedback_st_symbol@@@ (0) Bs rx gain (61) Transmit Receive transition gap (units: PS) (296) Minimum PHY rate for Unsolicited Grant Service (QPSK 1/2 (0)) @@@Text for cqich_bwreq@@@ (1) Initial value of code group of initial ranging. [0..255] (0) Time interval between UCD and DCD mesages (units: frames) [10..4000] (0x00C8) @@@Text for harqack_no_symbol@@@ (3) Encoding-type of DL map (0) @@@Text for timing_gap_offset@@@ (-748) }}}