close
Warning:
Can't synchronize with repository "(default)" (/common/SVN/wimax does not appear to be a Subversion repository.). Look in the Trac log for more information.
- Timestamp:
-
Apr 26, 2012, 12:42:33 PM (12 years ago)
- Author:
-
seskar
- Comment:
-
—
Legend:
- Unmodified
- Added
- Removed
- Modified
-
v7
|
v8
|
|
35 | 35 | |
36 | 36 | || General Configuration: configure the BS Id with the combination of [wiki:WiMAX/00/01#a1.4WiMAXOIDandIPAddressAssignment first three hex digits from the GENI OID and the last three based on your campus address assignment]. || [[Image(A4GGeneralSetup.jpg, width=300, align=right)]] || |
37 | | || SNMP Configuration: In addition to read and write community strings, one should specify trap destination IP address to match your controller IP address. || [[Image(A4GManagemenSetup.jpg, width=300, align=right)]] || |
| 37 | || SNMP Configuration: In addition to read and write community strings, one should specify trap destination IP address to match your controller IP address. || [[Image(A4GManagementSetup.jpg, width=300, align=right)]] || |
38 | 38 | || Management IP Configuration: Enter controller PC IP address as well as subnet mask and IP address of the default gateway. Management VLAN support and corresponding VLAN should be also configured. NOTE: If using trunk to connect the BS, it is quite important to make sure that the switch port to which the BS is connected has appropriate handling for untagged packets (i.e. that it labels untagged packets with the management VLAN). || [[Image(A4GSNMPSetup.jpg, width=300, align=right)]]|| |
39 | 39 | |