=== !AirSynergy 2000 === [[TOC(cLTE*, depth=3)]] ==== Hardware Installation ==== Fully connected !AirSynergy without weatherproofing covers should look like this: [[Image(airsynergy_connections.jpg, width=400px)]] || 1. || GPS || TNC connector to GPS antenna || || 2. || Power || Connect power cable to -48 power supply with the provided cable|| || 3. || Serial Console (optional) || If needed for debugging || || 4. || Networking || Copper ethernet (1000BASE-T) || [[br]] ===== Power Supply ===== The !AirSynergy supports direct connection to a -48VDC nominal power source. [[br]]Operating Voltage Range: -40.5 to 57 VDC A power supply capable of 120W or greater is recommended (eg. Mean Well CLG-100-48). [[Image(Slide2.PNG, width=600px)]] ====== Power Supply !Connector/Cable ====== The !AirSynergy supports direct connection to a -48VDC nominal power source. Operating Voltage Range: -40.5 to 57 VDC A power supply capable of 2A or greater is recommended (eg. Mean Well CLG-100-48). Use the provided power connector and cable to connect the basestation to the power supply. [[Image(airsynergy_power_cable.jpg, width=250px)]] Wire colors: || V+ || black wire || || V- || white wire || [[br]] ===== Network Connectivity ===== Network connectivity is done via copper gigabit ethernet (1000BASE-T). [[br]] ===== Serial Debug ===== The base station has a 9 pin connector (hidden behind a black hex bolt next to the port marked "ETH") which allows access to the serial console. This is useful for recovery purposes when the base station does not respond via software, SSH, or web interfaces. See [wiki:cLTE/cHardware/cAirspanLTEBaseStationSerialConsole Airspan LTE Base Station Serial Console] for information on cable construction and serial port parameters.