|Version 31 (modified by 4 years ago) ( diff ),|
Table of Contents
Fully connected AirSynergy without weatherproofing covers should look like this:
1. GPS TNC connector to GPS antenna 2. Power Connect power cable to -48 power supply with the provided cable 3. Serial Console (optional) If needed for debugging 4. Networking Copper ethernet (1000BASE-T)
Power Supply & Connector/Cable
The AirSynergy supports direct connection to a -48VDC nominal power source.
Operating Voltage Range: -40.5 to 57 VDC
A power supply capable of 120W or greater is recommended (eg. Mean Well CLG-100-48).
Use the included power connector and cable wired up as follows to connect the basestation to the power supply.
Wire Color Connect To black V+ white V-
Note the triangular key on the outer plastic ring between the V+ and V- pins.
Network connectivity is done via copper gigabit ethernet (1000BASE-T).
The base station has a 9 pin connector (hidden behind a black hex bolt next to the port marked "ETH") which allows access to the serial console. This is useful for recovery purposes when the base station does not respond via software, SSH, or web interfaces. See Airspan LTE Base Station Serial Console for information on cable construction and serial port parameters.