Version 5 (modified by 8 years ago) ( diff ) | ,
---|
AirSynergy 2000
Table of Contents
Hardware Installation
AirSynergy Connections:
1. Power Connect power cable to -48 power supply with the provided cable; [Mean Well SP3XXX] ![]()
2. Networking Insert SFP+ and connect; list of supported SFP+s 3. Serial Console (optional) If needed for debugging
Fully connected AirSynergy without weatherproofing covers should look like this:
Power Supply
The AirSynergy supports direct connection to a -48VDC nominal power source.
Operating Voltage Range: -40.5 to 57 VDC
The base station end of the power cable uses a Molex 0039012040 housing (Digikey: WM3701-ND) with Molex 0039000039 pins (Digikey: WM2501-ND).
Housing:
Power connector pinout:
Compatible SFP+ Adapters
The following SFP+ adapters were tested for compatibility with the AirSynergy.
Fiber connections were tested with:
Type Manufacturer Model MMF Intel FTLX8571D3BCV-IT SMF Intel FTLX1471D3BCV-IT
CAT5/CAT6 (Copper Gigabit Ethernet)
Manufacturer Model Note Avago abcu-5730arz 1g (T)
Multi-mode Fiber
Manufacturer Model Note Dell ftlx8571d3bcl 1g/10g (SR) Finisar ftlx8571bcv Intel afbr-703sdz-in2 Iwnetworks iw-trsfpl-sr Finisar sfp-10gsr-85 Trendnet teg-mgbsx Cisco 1000base-sx
Single-mode Fiber
Manufacturer Model Note Dell ftlx1471d3bcl
Software Installation
Attachments (3)
- airsynergy_connections.jpg (150.3 KB ) - added by 7 years ago.
- airsynergy_power_cable.jpg (60.6 KB ) - added by 7 years ago.
- power_supply.png (322.1 KB ) - added by 7 years ago.
Download all attachments as: .zip
Note:
See TracWiki
for help on using the wiki.